Plauqe mounting issue My plaque mount has mounting issues. I will send a photo of the crease.
KeenART:
This was not due to a our error. This poster had very bad water or moisture damage to the it. So where the image has been damp or wet the paper shrinks and will not lay flat (you can notice this by rubbing your hand over the poster and it does not lay flat. Therefore when we laminate and drymount the print to the MDF wood the area where the poster has been moisture damaged will crease. Unfortunately we get a lot of these damaged prints sent to us every week as it is a cheap way to have it protected. I hope this helps. If you have any further questions on this please give us a call or reply email.
Trini, | We're very pleased Just wanted to pass along that we've received our plaque mounting and it looks great! We're very pleased and I've sent you the balance from the invoice via paypal.
Tom, | It was my first time ordering from KeenART, so I was apprehensive. However, they did a great job. I sent in posters to be mounted and the process was easy and the turnaround was reasonable. The mounted posters look great! They were packaged very well to protect them also. I am very pleased.
Barry S., | Deeply dissatisfied. Hello: I’m sending you this message to express my disappointment in the two custom-made picture frames I received today which made up my order.
First of all I indicated in the note section for each frame that I wanted to be able to either hang my frame on the wall or simply place it standing up on a table and asked that a back for these purposes be included with each frame. I did not receive anything close to what I requested, in fact nothing close. As a result I now have two frames in my possession with no back for either which will allow or permit me to stand my frame or frames up on a table or a mantle.
Secondly, the two Styrofoam or foam backs which accompanied each frame is not near thick enough to be flush with the top, sides or bottom parts of either frame. As a result it looks as though I will have to insert something to fill in the space to enable to foam back to come flush with the frame itself.
Lastly it looks as though I received some hardware to be able to hang the frame on a wall but no picture wire accompanied the hardware for this particular purpose.
Deeply dissatisfied.
Roger, |